DM3200 and cubase 6 full surface control but no audio

Discussion in 'TASCAM DM-3200 & DM-4800' started by Thom Droney, Mar 17, 2020.

  1. Thom Droney

    Thom Droney New Member

    Joined:
    Nov 2019
    Messages:
    2
    Likes:
    2
    Gear:
    Tascam 3200
    I have successfully integrated control surface capabilities of dm3200. Using FireWire Iffw mkii...Locked to card slot 1. I think I did the correct procedures in routing thru the routing manual found on this forum.

    I just can’t get audio into dm3200 and thru phone out

    Attached Files:

  2. Arjan P

    Arjan P Well-Known Member

    Joined:
    Oct 2012
    Messages:
    1,017
    Likes:
    389
    From:
    Netherlands
    Gear:
    DM3200 IFFW
    Hi Thom, and welcome to the forum! - Just to let you know, there is a separate forum section about the DM-3200 and -4800 digital mixers..

    Anyway, to be able to answer your question more info is needed. First, what computer are we talking about - Mac or PC? Then, if the OS sees the IFFW/DMmkII (driver installed) your 32 inputs and outputs should be available to Cubase. BTW, the control surface stuff for these mixers uses the USB connection, FireWire is mainly for digital audio.
  3. Thom Droney

    Thom Droney New Member

    Joined:
    Nov 2019
    Messages:
    2
    Likes:
    2
    Gear:
    Tascam 3200
    Thanks.....went and reinstalled drivers for Iffw mkii
    Works like a charm.

    Scouring site thread pertaining to meter bridge / time code sync

    Thanks again ,..you and this site was the reason I knew I could get it done
    Arjan P and -mjk- like this.