Route Talkback to Phones Outputs

[lakir]

Hallo
I am new with Tascam equipement (DM3200) and it is very complicated to me.
I've used so far Digi 003 console with Pro Tools 10,it's plug and play hardware
I'm interested how to route talkback to phones outputs?

PS. Sorry for my english

 

[Arjan P]

Hi Lakir, and welcome! The Talkback mic on the DM is normally output to the Studio outputs, while the mixer's headphone connections are hard wired to the Stereo Outputs. I'm not sure if Talkback can be routed to the stereo output, but if that is the case you're very likely to have a feedback loop in your listening environment. Personally, I have routed the Studio outputs to my headphone amp, where the artist is connected to. Hope this helps.

 

[lakir]

Thanx Arijan for help,I did the same as you with headphone amp,problem solved
I have another problem with midi,pro tools does not get midi signal from my master keyboard?! I tried to connect on if-fw/dmmk2 and dm3200 midi in but nothing. I use dm3200 to control pro tools without any problem but no midi signal from master key?!
If someone had a similar problem,any solutions?

 

[butch]

Hi everybody
How to route talk back to aux 1/2?

 

[Headroom]

As Arjan wrote, TB is routed to the Studio Outputs. That cannot be changed. And normally aux 1 and 2 are used to provide the monitor signal. I too have the Studio Outputs routed to my headphone amps.
Apart from that I have the Studio Outputs routed back: two assignable returns - two channels - one aux send - one assignable send - studio amplifier. In this way I use TB when monitoring through speakers instead of headphones. Have to be careful with the volume though, to avoid feedback.

 

[butch]

Thx you