I’ve replaced the capstan and control belts on a 240v/50hz UK version of the Tascam 244 and still having problems getting the transport back in action. Maybe someone familiar with this procedure can help...
After fitting new belts I power up the unit and put a tape inside. The tape sensors at the top initiate the capstan motor as soon as the tape is inserted, even though none of the transport controls are engaged. The belt generally rolls off the capstan motor wheel after a about 10 seconds, but while the belt is on, the transport is not affected, the tape doesn’t go anywhere....
I ordered another belt of the smaller size, I think this is used on the 60hz models. It looks like a better fit but I still get the same problem...
Any ideas?!
After fitting new belts I power up the unit and put a tape inside. The tape sensors at the top initiate the capstan motor as soon as the tape is inserted, even though none of the transport controls are engaged. The belt generally rolls off the capstan motor wheel after a about 10 seconds, but while the belt is on, the transport is not affected, the tape doesn’t go anywhere....
I ordered another belt of the smaller size, I think this is used on the 60hz models. It looks like a better fit but I still get the same problem...
Any ideas?!
Last edited: