- Joined
- Jan 13, 2018
- Messages
- 134
- Karma
- 24
- Gear owned
- Recorder, Guitars, Keys
I want to record my guitar amp, and below is my equipment set-up:
1. Ran guitar cable from Amp’s Line-Out to Tascam DP-32sd Input H.
2. Ran guitar cable from Effects Rack Output to Amp’s Input.
3. Ran guitar cable from Guitar to Effects Rack Input.
There were problems:
With the amp volume turned-up more than it should be, I had a strong signal on the Tascam Screen, but low volume in my headphones. I also had to cut the Trim Knob almost off to stop it from over-loading. Still, I was occasionally getting over-load distortion in my headphones. Needless to say, I need some advice. If anybody on the forum has any suggestions, I would be happy to hear them.
MY GEAR:
1. Fender Telecaster Guitar
2. Peavey LA 400 Amp
3. Boss Effects Stomp-Pedals (L to R):
* Pwr Supply/Tuner Pedal
* Distortion Pedal
* Phaser Pedal
* Delay Pedal
* Reverb Pedal
4. Tascam DP-32sd
NOTE: The Peavey LA 400 is a great amp with power to spare. However, prior to using the LA 400, I tried this same set-up with a much smaller amp. I had the same problem with both amps.
1. Ran guitar cable from Amp’s Line-Out to Tascam DP-32sd Input H.
2. Ran guitar cable from Effects Rack Output to Amp’s Input.
3. Ran guitar cable from Guitar to Effects Rack Input.
There were problems:
With the amp volume turned-up more than it should be, I had a strong signal on the Tascam Screen, but low volume in my headphones. I also had to cut the Trim Knob almost off to stop it from over-loading. Still, I was occasionally getting over-load distortion in my headphones. Needless to say, I need some advice. If anybody on the forum has any suggestions, I would be happy to hear them.
MY GEAR:
1. Fender Telecaster Guitar
2. Peavey LA 400 Amp
3. Boss Effects Stomp-Pedals (L to R):
* Pwr Supply/Tuner Pedal
* Distortion Pedal
* Phaser Pedal
* Delay Pedal
* Reverb Pedal
4. Tascam DP-32sd
NOTE: The Peavey LA 400 is a great amp with power to spare. However, prior to using the LA 400, I tried this same set-up with a much smaller amp. I had the same problem with both amps.