I am using Logic and for some reason Logic is only recognizing input from the Model 12 only on channel 1.
I have signal outputting the Model 12, on 2 channels - for guitar and scratch vocal - and see the levels - but there is no input into Logic to these channels. If I set the input to channel 1 though, Logic will accept both tracks, as a mix from the Model 12.. I have no idea why this is happeing.
It was working before and now it is not.
I think there is a simple setting that has been turned off or undermined, either in Logic or (most likely) in Logic. But I don't know where to find it.
Does anyone have a "checklist" or have dealt with a similar issue?
Is there a setting in the Model 12 that I am overlooking?
thanks for any help.
I have signal outputting the Model 12, on 2 channels - for guitar and scratch vocal - and see the levels - but there is no input into Logic to these channels. If I set the input to channel 1 though, Logic will accept both tracks, as a mix from the Model 12.. I have no idea why this is happeing.
It was working before and now it is not.
I think there is a simple setting that has been turned off or undermined, either in Logic or (most likely) in Logic. But I don't know where to find it.
Does anyone have a "checklist" or have dealt with a similar issue?
Is there a setting in the Model 12 that I am overlooking?
thanks for any help.
