The stereo button on the "Tascam DM 3200" console plays mono sound

[frapesc]

Hello friends. Sorry but I still do not handle the Tascam DM 3200 console. In the monitoring system, when the stereo button is pressed, the sound that is played is mono. However, when you press the aux 1 button, the sound that is played is stereo. Could someone help me to press the stereo button to sound be stereo? Thank you.

 

[Headroom]

I suppose you have your monitors connected to the control room output terminal?
If you then hear mono while 'stereo' is selected, that means there is the same signal on the stereo L and R busses. Maybe you are not panning your sound sources correctly to stereo L/R? Did you assign the source channels to the stereo buss (press the stereo button in the assign section) and set the pan for each channel?

 

[frapesc]

Thanks friend. The problem is solved

 

[Peter Batah]

Perhaps you would like to share the resolution with the rest of the forum community.

 

[frapesc]

Hello, the problem was solved when you have to do the routing of the channels. In my case, I had the stereo divided into channels 17 and 18 to be able to control the signal L and R independently, but the routing of the two channels was wrong.