Configuring Model 16 with WIN11 and Cakewalk Sonar (by Band Lab)

[M E Bouchard]

Newbie to the forum here...

I've had my Model 16 for about 6 months and it worked fine with my old WIN10 system and the legacy Cakewalk by Band Lab. Last week I built a new WIN 11 PC and installed the new version of Cakewalk Sonar (the older version is being retired). I also have the latest version of the Model 16 driver. The problem I'm having is that I can p[lay back through the USB but cannot send to my DAW through the interface. I see the signal in the channel meter in the Tascam driver UI, and the mixer channels are showing up in my DAW, but no signal is coming through. The Sonar channel meters are blank.

My WIN10 system took a while to get everything configured properly, hoping that's same issue here.

Will appreciate any help with this. I've also opened a thread on the Sonar, and SOS forums.

Cheers

 

[M E Bouchard]

I found the issue, the Tascam Model 16 uses an ASIO based driver. The "Driver Mode" setting needed to be "ASIO" where I had it set to "WASAPI Shared" which is probably why it wasn't working.
Back to moving forward... all good