MU-2624 meter bridge unit

[Tapeoholic]

Hi all,

I recently purchased an all analog M-2600 MKII mixing console, which I'm still waiting on delivery of. The board includes the MU-2624 meter unit.

I was already informed from the seller that the two vu meters on the Meter bridge are not functioning, but that all bar-graph meters are.

I'm trying to get on jump on getting the vu's up and running, but so far I'm finding no technical docs on the MU-2624.

I wouldn't be surprised if there was never a Tascam owners manual for it (which probably wouldn't help me anyway) as it's basically a passive until that gets plugged in and only looked at! But if I could find a service page, schematic, block diagram, or priceless advice from a Forum member who might have dealt with a MU-2624, or similar, then that might be my next step (first step??) in the repair (or replacement?)

Any help either with past experience or with any elusive documents would be much appreciated!

 

[Tapeoholic]

No service manual or schematic likely needed on this job...
I received my delivery of the MU-2624 meter bridge, took off the access panels and soon found that the pcb for the vu meters had a physical crack in it its entire length. Of course disrupting several of the traces (at least!). I considered attaching as many jumpers as would be needed. I spotted about 6 damaged traces. Might be an easy job, maybe not.

I then did a little searching and found that the pcb might be avaliable from Teactascamparts.com
I'm waiting to hear back from them as to the compatibility of what they have and what I need.

Any suggestions or recommendations from the group would be very welcome.

Photos of the damaged pcb are attached. I have no reason to think I need either of the actual vu meters. Thanks