Routing with DM3200 + Cubase + Virus TI

[djnoshow]

Hi guys,
I finally setup my studio again, after 6 years hiatus. So things are rusty
So I have a DM3200, Cubase and Virus
I'm wanting to route the Ti USB outputs through the DM. I don't know how to upload pics, as I don't have access the site says
I'm wondering how people have done this.
I'm not quite sure on the input selection on the DM.
I have a TDIF on slot2 (which is used by my AKAI Z8), and have tried all slot 1 (1-32) settings (routing to input 9&10)
The TI is set to 3 ins/0 outs and midi channel 1 is set to USB1L&R, and VST connections routed to Device port 9&10
I don't know what I'm missing with the routing.
Ultimately, I want to route and monitor the following:
TI Midi #1 -> USB1L&R -> DM In 9&10
TI Midi #2 -> USB2L&R -> DM In 11&12
TI Midi #3 -> USB3L&R -> DM In 13&14

 

[Headroom]

I don't like to see your question unanswered, but I don't fully understand what you are trying to accomplish. Note that you cannot connect USB to audio inputs on the DM. You'll have to separate the routing of the audio and the midi.

 

[djnoshow]

Dunno wht, but I ca't post a pic of a diagram I drew

 

[djnoshow]

So, just say.
The TI USB, that will be connected through VST connections of Cubase' ASIO drivers. I will be using for recording
Then I want to monitor those ASIO inputs through my DM

 

[Peter Batah]

Dunno wht, but I ca't post a pic of a diagram I drew

Use an external hosting source like Imgur for posting pic

https://imgur.com/

 

[djnoshow]

https://ibb.co/611b2RX