Solo buss and aux

[Antony]

Can I solo the buss and aux layer. I know I can monitor whats been sent to the aux but I want to solo the buss and aux layer
Antony

 

[TascMan]

I hate to see a thread go by without a reply. I tried assigning a mix to an aux channel, then I tried pushing the SOLO button, and, NO, it did not solo. Same with the 16 busses. Since I haven't had a reason to do this in the past, that was the first time I had done it. Maybe someone here knows a bit more about soloing the auxes.

 

[Headroom]

The Solo switches are only found in the channel modules. So you cannot solo a buss or aux directly.
You can loopback a buss or aux to a channel and then solo that channel.

 

[Jarno]

INPLACE SOLO only works with channels, but if switch SOLO mode to PFL or AFL you can use it for AUX/BUSS also.

 

[Antony]

INPLACE SOLO only works with channels, but if switch SOLO mode to PFL or AFL you can use it for AUX/BUSS also.

I'm prosuming yopu mean ALT/Option then select Solo type pfl or afl. That didnt work for me, I still cant solo an Aux or Buss channel.

 

[Jarno]

You're correct. My fault. Must have been in some other digital desk I have worked with.