I had a DB25 cable made to the Tascam standard ( here if helpful https://tascam.jp/downloads/tascam/34/DB-25_Pinout.pdf). Ive confirmed the cable was made correctly, flipping the connections so that pins 12, 24 and 25 will windup on the other end of the cable at pins 6,18 and 19 respectively. Im trying to get an extra ADAT port on my Tascam DM3200 mixer and using this cable with a Tascam IF-TAD converter ( here if helpful Tascam IF-TAD). Ive confirmed that the cables was built correctly to the "crossover" specification above (I've actually tried 3 different cables wired for this format and two other IF-TAD interfaces and on all 3 DM3200 ports).
I cannot seem to manage to get the ADAT connection to sync, input yellow lights on the IF-TAD flash, both TDIF and ADAT lights, indicating no clock/sync. The DM3200 clock page says the TDIF in "unusable". The ADAT connection is to an RME DigiFace USB ( here is helpful RME DigiFace USB) which also says "no lock".
I have tried DM3200 as master and the DigiFace as slave, and vice versa, no luck with either configuration.
If anyone could shed some light on this it would be most appreciated.
Thank you,
RB
I cannot seem to manage to get the ADAT connection to sync, input yellow lights on the IF-TAD flash, both TDIF and ADAT lights, indicating no clock/sync. The DM3200 clock page says the TDIF in "unusable". The ADAT connection is to an RME DigiFace USB ( here is helpful RME DigiFace USB) which also says "no lock".
I have tried DM3200 as master and the DigiFace as slave, and vice versa, no luck with either configuration.
If anyone could shed some light on this it would be most appreciated.
Thank you,
RB
)
