- Joined
- Jul 17, 2020
- Messages
- 2
- Karma
- 1
- Gear owned
- Tascam DP 24
I've had a DP24 for a about 6 years and made many recordings on it. In the past year I've started experiencing a static noise when adjusting the trim knobs. It started with just one or two, but now all eight do it. When I adjust the knob to the right it is not allowing the full input from the mic or input device, the level is low. If I tap or twist the knob back and forth the signal will sometimes suddenly increase to the correct level. Is anyone else experiencing this problem. Can you suggest any solutions?