Tascam Model 12 and Cakewalk

[Mark Nicholson]

Hi Gang,

I'm trying to set up my Model 12 to use as a DAW Controller, in this case with Cakewalk. I followed the advice in the DAW Controller manual, page 11:

and the square (stop) button on the Model 12 is illuminated, which should show that remote control is enabled. Good job! Cakewalk sees it as a MIDI device:

But, when I look at Audio devices, cakewalk sees the Model 12, but it is not enabled:

and I cannot use any of the inputs as inputs for a track:

If I create a MIDI track, then Cakewalk sees the Model 12:

But it just won't see it as an audio device. I have the Mode switch for all my channels set to PC. Where am I going wrong?

- Mark

 

[Mark Nicholson]

I think I fixed it. I had to remove the Yamaha Steinberg USB audio. Not altogether sure why, but it's now working!

 

[Mark Nicholson]

This is a Cakewalk question rather than a Tascam question, but does anyone know why Cakewalk would only allow one Audio device?

I can use either the Yamaha or the Tascam, but not both.

 

[Morgelec]

That looks like the driver. I have a Yamaha interface and I don't think I can run both at same time.