If-AN/DM routing issue

[Domino]

If this has been asked before, my apologies. I just installed the 8ch analog expansion in slot 2 for 8 additional mic inputs. On the DM4800 meter screen, 25-32 show fine individually but in Cubase 6 each channel is feeding into all 8 collectively. Any helpful suggestions?

 

[B2RPW]

Is it possible you have all 8 channels routed to the same bus on the board and in cubase you have that bus set as your input source? The way to determine your buss assignments on the board is by pressing select on channels 25-32 while looking at the bus assignments on he left side of the board. As you cycle through 25-32 you should be able to see to which busses each channel is assigned.